Sharp MX-2300 G Installation Manual page 51

3) Remove the earth cord and disconnect the power plug of the
main unit from the power outlet.
B. Removal of the paper holding arm unit
1) Push up the section A to disengage the pawl, and remove the
paper holding arm and the paper holding arm holder together
as a unit.
* Be careful to remove both of the paper holding arm (which is
easily removed alone) and the paper holding arm holder.
2
C. Installation of the interface pass unit
1) Open the front cabinet. Remove the screws, and remove the
front cabinet upper.
2)
3)
4)
A
5)
MX-2300/2700 N/G MX-RBX1, MX-FNX2 8 – 2
Disengage the pawls, and remove the paper exit tray cover.
Remove the screws, and remove the paper exit tray.
Remove the paper exit full detection actuator (A), and install
the reverse detection actuator (B) (package part No. 7).
* Be careful of the installing direction of the reverse detection
actuator.
1
A
B
Engage the projection of the main unit frame with the hole in
the right cover plate (package part No. 1), and install the right
cover plate and fix it with the fixing screw A (package part No.
4).
* Be sure to clamp and fix the paper exit tray shifter side plate
with the fixing guide.
2
B