Hisun STRIKE 1000 Owner's Manual page 24

2. Set gear shift lever to the "NEUTRAL" position.
① Gear shift lever.
(H) High Range
(L) Low Range
(N) "Neutral" position
(R) "REVERSE"
3. Push the accelerator pedal down slowly.
① Accelerator pedal
② Accelerator pedal depressed
1. Insert the key into the key switch and turn it to
START. (Starts the engine.)
OFF (Stops the engine)
OPERATING THE ENGINE
ON
◆ Display and Warning Lights
1. When the key is turned to "START", lamps (1
2. The parking brake warning lamp (2 parking
IMPORTANT
Relying on the engine warning lights is never
enough. Never fail to conduct daily checks
carefully by referring to Pre Operation Check " in
"PERIODIC SERVICE" section.
3. Turn the key to the "START" position and
release when the engine starts.
IMPORTANT:

■ Cold Starting
When
-15℃( 5℉), and the engine is very cold. If the
engine fails to start after 5 seconds, turn off the key
for 30 seconds and start again.
6-2
(Engine runs or headlights on)
engine oil pressure) should come on. If trouble
codes occur at any location with the engine
running, the warning lamp corresponding to
that location comes on.
brake) comes on while parking brake is
applied and goes off when it is released.
Because of safety devices, the engine will not
start except when the gear shift lever is placed
in the "NEUTRAL" position and the brake is
depressed.
the ambient temperature is below