Hisun STRIKE 1000 Owner's Manual page 48

1. Park the vehicle on a flat surface and raise the
cargo bed.
2. Remove the oil filter.
3. Put a film of clean engine oil on the rubber
seal of the new filter.
4. After the new filter has been replaced, the
engine oil normally reads lower on the dipstick.
Make sure that the engine oil does not leak
through the seal and check the oil level on the
dipstick after running the engine and allowing
it to cool. Then replenish the engine oil up to
the prescribed level.
① Bolt; ② Cover
③ "O" seal ring;
④ Engine oil filter
IMPORANT:

To prevent serious damage to the engine, use
only a genuine Hisun filter.
■ Replacing Engine Oil
CAUTION
To avoid personal injury:

Be sure to stop the engine before changing
oil.

Allow engine to cool down sufficiently, oil
can be hot and can burn.
1. Park the vehicle on a flat surface, raise the
cargo bed, and apply the parking brake.
2. Remove the oil filter / oil drain plug and drain
all of the old oil.
PERIODIC SERVICE 10-14
3.
4.
5.
Oil capacity
① ~② Oil level is acceptable within this range
③ Dipstick
Checking Brake Pedal


◆ Checking the brake pedal free travel
Proper brake pedal
1.
2.
3.
Put a film of clean oil onto the seal of the new
filter. Reinstall the oil filter cover. Reinstall the
drain plug.
Add the prescribed amount of oil to the engine
After running the engine for a few minutes,
stop the engine and check the oil level again.
Add oil to the prescribed level.
[Filter exchanged]
④ dipstick location
CAUTION
Stop the engine and chock the wheels before
checking brake pedal.
If the free travel is outside of the specifications
contact your local dealer for adjusting the
brake.
free travel
Release the parking brake.
Slightly depress the brake pedal and measure
free travel at the top of the pedal stroke.
If brake pedal free travel is outside of the
1L (1.05U.S. qts.)
7 to 14mm
(0.3 to 0.6 in.)On the
pedal