Specifications And Requirements; Supply Water Quality Requirements - Ecosoft RO 5-36 Installer And User Manual

REVERSE OSMOSIS SYSTEM INSTALLER AND USER GUIDE
2. SPECIFICATIONS AND COMPONENTS

2.2. SPECIFICATIONS AND REQUIREMENTS

Parameter
1 Main pressure (no booster pump), barg
2 Main pressure (booster pump installed), barg
3 Tank bladder pressure, barg
4 Feed water temperature, °C
5 Weight of the system (base model), kg
6 Ambient temperature, °C
7 Water supply connection
8 Filter dimensions, H×W×D (basic assembly), mm
9 Tank dimensions, H×W×D, mm
* If supply water pressure is below required value, purchase pumped model or fit your existing filter with booster pump. If the
pressure in the water system is above the limit, it is necessary to install a pressure regulator on the main pipe.
** If pressure in tank bladder is outside this range, it is necessary to pump up or release the pressure until it conforms to the
requirement.
*** If supply water temperature is up in the range of +20...+30 °C, rejection of impurities will be decreased and system capac-
ity increased, bringing about an increase in TDS. Using the product with supply water temperature in excess of +30 °C is not
recommended.

2.3. SUPPLY WATER QUALITY REQUIREMENTS

Index
1 pH
2 TDS
3 Hardness
4 Free chlorine
5 Iron
6 Manganese
7 Chemical oxygen demand
8 Total bacterial count (TBC)
9 E. coli titer
* If water supply does not meet the requirements, service life of membrane and/or pre-filter cartridges may be shortened.
** If your home is supplied with raw wellwater, perform laboratory test of your water before installing a reverse osmo-
sis filter. If any of your water indices exceed the limit, consider using a water treatment system to correct supply water
quality. Refer to water treatment specialists or companies for advice and proper equipment selection.
This manual is the intellectual property of Ecosoft. Copying and reprinting is prohibited. © 2014
*
VALUE
6,5-8,5
<1500 ppm
<500 ppm CaCO
<0.5 ppm
<0.3 ppm
<0.1 ppm
<5 ppm O
<50 CFU/mL
<3
7
Value
3-6*
2-4,5
0,4-0,6**
+4...+30***
6
+5.....+40***
½" thread
350x450x150
350x260x260
**
(<28 °dH)
3
2