Table of Contents
Advertisement
REVERSE OSMOSIS SYSTEM INSTALLER AND USER GUIDE
4. STEPS FOR INSTALLING REVERSE OSMOSIS SYSTEM
Before installing a domestic reverse osmosis filter please carefully read this instruction.
4.1. VERIFY YOUR SETUP
1) Check that all parts are in the package. Do not open the plastic bags with filter parts before you
make sure everything is in place to be able to return faulty/incomplete package.
2) Check conformity of your local variables to requirements specifications:
Main pressure*
Check water pressure at mains
before installing the product. Com-
pare to the requirements
in paragraph 2.2.
*Refer to paragraph 2.2 for recommended measures in case any of the above variables does not meet the requirements.
— verify that your product is as specified in paragraph 2.2;
— verify that your supply water quality** meets the requirements in paragraph 2.3.
**If supply water quality does not meet the requirements, it is necessary to consult with a water treatment specialist.
3) Before installing the system, make sure there is enough space for both the filter rack and the pres-
sure tank under the sink. In case there is not enough available space, pressure tank can be placed
in a separate location provided that the yellow tube's length is sufficient to connect it to the rest of
the system.
4) Install the system per the guidelines of this manual.
4.2. INSTALLATION PROCEDURE
CAUTION! This system has been tested by the manufacturer for leaks, so within the system the
presence of residual water is allowed.
Wash your hands thoroughly with anti-bacterial soap before handling tubes, cartridges, and
membrane.
This system should desirably be installed in places protected from direct sunlight and away from
heating appliances.
1.
Remove the reverse osmosis system from its packaging and check the equipment. Do not open the bag with compo-
nents. Note that you will not be able to claim missing parts if the bag is opened.
2.
Shut off water supply in your kitchen or whole home and open water tap where you are about to install the system
(on your kitchen sink) for 1 minute to relieve pressure in the system, and then close it.
This manual is the intellectual property of Ecosoft. Copying and reprinting is prohibited. © 2014
Tank pressure*
Check pressure in the tank bladder.
Compare to the requirements
in paragraph 2.2.
Supply water temperature*
Check temperature of supply water.
Compare to the requirements in
paragraph 2.2.
20
Hide quick links:
Advertisement
Table of Contents
