Rewind Starter - Rotax 503 UL Operator's Manual

14.2) Rewind starter:
Check cord condirion every 10 hours. Replace when wom or frayed.
To change the safter rope, follow the procedure outlined (the numbers stated in brackets refer
to the illustrarion).
First remove the rewind starte! assembly from the engine.
Second, remove rhe snap ring (0, loop spring O, circlip O, pawl lock @, and the pawl 6.
Pull out the starter rope fully to the end, hold staner housing O and rope sheave O together
in
rheir posirion. Therc is an opening in the rcpe sheave. The key clamp O visible in the opening
has to be pushed out in the opposite sense of the pul ling dircction. pull the rope out ofthe
ropi
sheave.
Then insert the new staner rope into the rope sheave, fir the key clamp in the same position
as
ir was and push ir ro be tight. Refir the pans 6, 6, O, @ and O.
/l
WARNING: Do not rcmove spring container O, this might cause injunes.
Do nor operate thc engine if the rc$/ind starter is defectivc-
Most starter problems are due to improper opemfion.
ebe@
/ . , - : - : - ,
--l==-!*Y==
0
o0