Problem Solving Guide - Miele KM 3014 Operating And Installation Instructions

With the help of the following notes, minor faults in the performance of the
appliance, some of which may result from incorrect operation can be put right
without contacting the Service Department. saving you both time and money.
The following guide may help you to find the reason for a fault, and to correct it.
You should, however, note the following:
,
Repairs to the gas and electrical components of this appliance must only
be carried out by a suitably qualified and competent person to ensure safety.
Repairs and other work by unqualified persons could be dangerous. The
manufacturer cannot be held liable for unauthorised work.
Problem
The burner does not
ignite after several
attempts.
The gas flame goes
out after ignition
The flame pattern
has changed
The ignitor on the
burner does not
spark.
Possible cause
The burner is not correctly
assembled.
The gas supply tap is turned off. Turn on the gas supply tap.
The burner is wet or dirty.
The flame slits are blocked
and/or wet
Check whether the mains fuse
has tripped.
The flames are not touching the
ignition safety device, it is not
hot enough:
- The burner is not
correctly assembled.
- There is dirt on the
ignition safety device.
The burner is not correctly
assembled.
The burner head or burner cap
holes are dirty.
Check whether the mains fuse
has tripped.
Food residues between the
ignitor and the burner cap.

Problem solving guide

Remedy
Assemble the burner correctly.
Clean and dry the burner.
Clean and dry the flame slits.
If it has, contact a qualified electrician or the
Miele Service Department.
Assemble the burner correctly.
Remove any soiling.
Assemble the burner correctly.
Remove any soiling.
Call a suitably qualified electrician or Miele
Service.
If there is, remove it carefully (see "Cleaning
and care").
29