Throttle Cable Installation - Ferris 41031301 Operator's Manual

2-14 Throttle Cable Installation

To install the throttle cable kit to the ROPS (roll over
protection system), place the 3/8" U-Bolt P#(K0136)
onto the ROPS with the threads facing the front of the
mower. Next slide on the throttle mount plate assembly
P#(A0666) with the rivets also facing toward the front of
the mower. Tighten the throttle mount plate assembly
securely to the ROPS using (2) 3/8"-16 nyloc nuts
P#(K1216) (Figure 2-14a). With the throttle cable facing
toward the engine/blower/blade assembly, place the
throttle base plate over the rivets, Slide the throttle
cable kit to the right, moving the smaller end of the slot
over the rivets. When positioned correctly, the throttle
spring plate will snap into place (Figure 2-14b).
NOTE: If mower is not equipped with a ROPS Intall the
throttle cable kit to the top frame assembly P#(A0585)
using the same steps as above. Make sure to locate the
throttle cable kit were it can be easily accessed from the
operator's seat.
To remove the throttle cable kit, lift the throttle spring
plate and slide the throttle kit to the left.
Route cable over upper hose as shown in Figure 2-14c.
Figure 2-11a
Properly Assembled
Throttle Cable Kit
(1) 3/8"-16 U-Bolt
(2) 3/8"-16 Flange Nuts
Figure 2-11b
Throttle Base Plate
Throttle Spring
Plate
Figure 2-14c
Attach J-Clip P#(K1455) onto blower housing using the
existing bolt located on blower housing. To fasten the
throttle cable end to the engine, place the throttle
control lever into the "stop" position. Rotate the engine
throttle lever to the "stop" position. Thread the wire end
of the throttle cable into the engine throttle lever eyelet
ROPS and tighten the screw. Thread the cable through the j-
or
clip and then fasten the throttle cable sleeve to the
Upper Frame Assy.
clamp on the engine throttle (Figure 2-14d). Rotate the
throttle control lever into the "fast" position to check for
proper installation.
NOTE: Cable sleeve may need to be cut, depending on
Throttle Mount
the engine type. Once throttle cable is attached, pull the
Plate Assembly
box handle to dump the box and be sure the cable does
not alter the movement of the box.
Throttle
9
Throttle
Cable
Figure 2-14d
Engine
Throttle Lever
Throttle
J-Clip
Throttle
Cable Clamp