Installation And Removal Of Collection Bags - Ferris 41031301 Operator's Manual

2-20 Installation/Removal Of Collection
Bags
To install the bag onto the bag ring, first make sure the
bag ring end caps are fastened to the bag ring. Place the
seam openings of the bag onto the bag ring openings
and turn the bag until the slot bracket in the bag ring is
protruding from the opening in the bag (Figure 2-20a).
Do this for each of three bags.
Install the completed assemblies onto the support frame
and close the plastic top. Fasten both draw latches to
hold the plastic top closed (Figure 2-20b).
To empty the bag, remove the bag and bag ring by lifting
and sliding rearward. Grasp the loop on the bottom of
the bag, turn it upside down and empty the collected
debris (Figure 2-20c). Repeat for the other bags.
Reinstall all bags, line with plastic bags if desired, close
the plastic top and reattach the draw latches.
Plastic lawn and leaf bags, 33 gallon size, may be used
inside the cloth bags. Be sure to leave enough plastic
bag hanging over the frame so the plastic bags can be
twist tied before emptying (Figure 2-20d).
Figure 2-20a
Bag Ring
Bag Ring
End Caps
Figure 2-20b
Figure 2-20c
Slot
Bracket
Figure 2-20d
Cloth Bag
11
Draw Latches
Plastic Bag
Plastic Top
Grasp Bag
Here
Cloth Bag