Lower Stiffener Installation; Exhaust Deflector Installation; Debris Shield Installation; Lower Mount Tube Assembly Installation - Ferris 41031301 Operator's Manual

2-3 Lower Stiffener Installation

Attach the lower stiffener P#(B0611) to the left and right
lower main frame legs, using (4) 3/8"-16 x 1-1/4" HHCS
P#(K1192) and (4) 3/8"-16 nyloc nuts P#(K1216). Refer
to Figure 2-3.
Figure 2-3
Lower
Stiffener

2-4 Exhaust Deflector Installation

Fasten the exhaust deflector P#(C0062) to the right
lower main frame leg using (3) 1/4"-20 x ½" HWHTCS
P#(K0353). Refer to Figure 2-4.
Figure 2-7
Exhaust
Deflector

2-5 Debris Shield Installation

Fasten the debris shield P#(C0063) to the left and right
lower main frame legs, using (4) 1/4"-20 x ½" HWHTCS
P#(K0353). Refer to Figure 2-5.
Figure 2-5
(4) 1/4"-20 x 1/2"
HWHTCS
(4) 3/8"-16 x 1-1/4" HHCS
(4) 3/8"-16 Nyloc Nut
(3) 1/4"-20 x 1/2"
HWHTCS
Debris Shield
2-6 Lower Mount Tube Assembly
Installation
Fasten the lower mount tube assembly P#(A1400) to the
lower stiffener using (3) 3/8"-16 x 2-1/4" u-bolts
P#(K1119), (3) 3/8" flat washers P#(K0047), and (6) 3/8"-
16 nyloc nuts P#(K1216). Use the flat washers on the
slotted mounting holes located on the lower stiffener.
Position the engine mount arm assembly mount hole to
the right side of the mower. Refer to Figure 2-6.
Figure2-6
(3) 3/8"-16 U-Bolt
(3) 3/8" Flat Washer
(6) 3/8"-16 Nyloc Nut
2-7 Engine Mount Arm Assembly
Installation
Position the engine mount arm assembly P#(A0138) as
shown in Figure 2-7. Insert the engine mount arm
assembly into the lower mount tube assembly, and align
the mounting holes on both parts. Secure the engine
mount arm assembly, using (1) detent pin P#(J0248).
Refer to Figure 2-7.
Figure 2-7
Lower Mount
Tube Assembly
6
Lower Mount
Tube Assembly
Detent Pin
Engine Mount
Arm Assembly