Check Engine Oil Level; Engine Maintenance; Raise And Lower The Operator Support Cushion; Check / Fill Transmission Oil Level - Ferris SRS Z1 Series Operator's Manual

20
2. Do not fill above the bottom of the filler neck (A, Figure
21). This will allow for fuel expansion. If you are filling the
tank from a fueling station make sure that the nozzle is
inserted into the tank far enough that the splash guard (B)
contacts the opening of the filler neck.
21
3. Install and hand tighten the fuel cap.
NOTICE
Refer to your engine owner's manual for specific fuel
recommendations.

Check Engine Oil Level

Interval: Before Each Use
Refer to the engine operator's manual for dipstick and oil fill
locations and specific engine oil check and fill procedures.

Engine Maintenance

For engine maintenance schedules and procedures, please
refer to the engine operator's manual.
Raise and Lower the Operator Support
Cushion
This unit is equipped with a hinged operator support cushion
(A, Figure 22) which can be raised to gain access to the
service components underneath the control tower. Raise
the operator support cushion to gain access to the service
components underneath the control tower and lower the
operator support cushion for normal operation. A block of
wood can be used to support the operator support cushion in
the upright position while servicing the components beneath
the control tower.
22

Check / Fill Transmission Oil Level

Oil Type: SAE 20W-50 motor oil
This unit is equipped with two transmission oil tanks (A,
Figure 23). One transmission oil tank only supplies oil to one
transmission. The level of oil in both transmission tanks must
be checked, and if necessary, filled.
23