Conversion To Lp Gas - Rangemaster Professional+ FX 90 User's Manual & Installation Instructions

WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.

9. Conversion to LP Gas

Fig. 9.1
A
ArtNo.311-0010 Injectors
A – Jet, B – Internal injector, C – External injector
Fig. 9.2
ArtNo.061-0006 - 90SC - Removing the splitter
Fig. 9.3
ArtNo.270-0032 - 90 Prof+ FX - Removing the control panel
Fig. 9.4
ArtNo.0102-0011 - Screwing
the control valve bypass screw
B
C
Check in the 'Technical Data' section at the back of these
instructions that the cooker is convertible to the gas you
want to use.
This conversion must be performed by a competent
n n
person, in accordance with these instructions and
with the local supply company requirements.
Failure to convert the appliance correctly could
n n
invalidate any warranty or liability claims and lead
to prosecution.
The conversion instructions must be used in
n n
conjunction with the rest of the appliance
instruction, in particular for information on
Standards, cooker positioning, connection, hose
suitability, etc.
When servicing or replacing gas-carrying
n n
components, disconnect from the gas before
starting, and check that the appliance is gas sound
after completion.
DO NOT use reconditioned or unauthorised gas
n n
controls.
Disconnect from the electricity supply before
n n
conversion. Before electrical reconnection, check
that the appliance is electrically safe.
Injectors
Remove the burner caps and heads. Remove the old jets.
Fit the new jets: see 'Technical Data' section for correct jets.
Reassemble in the reverse order (Fig. 9.1).
Tap Adjustment
Disconnect from the electricity supply.
Remove all control knobs. Open the oven door. Undo the 2
screws on the oven beak (Fig. 9.2) and remove. Remove the
3 fixing screws on the underside of the control. The control
panel should drop down slightly. It is held at each end by two
holes in the top edge (Fig. 9.3) that locate on the tags on the
inner panel.
Lift the control panel clear of the tags and pull the control
panel forward.
Take care not to damage or strain the wiring.
Bypass Screw Adjustment
Turn the bypass screw on each control clockwise to the stop
(Fig. 9.4). Refit the control panel.
33