Cleaning Your Cooker; Daily Care; Cleaning For Spills; Hotplate Burners - Rangemaster Professional+ FX 90 User's Manual & Installation Instructions

6. Cleaning Your Cooker

Fig. 6.1
A
B
D
ArtNo.311-0032 Burner layout FSD
A – Cap, B – Head, C – Notch, D – Base, E – Electrode
Isolate the electricity supply before carrying out any major
cleaning. Allow the cooker to cool.
NEVER use paint solvents, washing soda, caustic
n n
cleaners, biological powders, bleach, chlorine based
bleach cleaners, coarse abrasives or salt.
C
DO NOT mix different cleaning products – they may
n n
react together with hazardous results.
All parts of the cooker can be cleaned with hot soapy water
– but take care that no surplus water seeps into the
E appliance.
Remember to switch the electricity supply back on and reset
the clock before reusing the cooker.

Daily Care

Cleaning the cooker is not a welcomed chore, but it has to be
done to maintain efficiency and appearance. Remember it
is better to wipe up any spills as they occur, this will prevent
them burning on and becoming more difficult to remove
later.
Make sure the flow of combustion and ventilation
n n
air to the cooker is unobstructed – for example by
build-up of fats or grease.
On Natural gas the burners flames should be a bluish colour
with, at most, a slight yellowish fringe.
On LP gas the flames may be "softer". The cooktop burner
flames may have a slight yellowish tip.
If the flame burns with a long white tip you should call for
service.

Cleaning for Spills

For spills and boil-overs that occur while cooking, turn off the
burner as soon as possible and allow it to cool. Do not clean
until the area is completely cooled down. Wipe up spills as
soon as possible.
Do not allow surplus water to seep into the cooker.

Hotplate Burners

The burner heads and caps can be removed for cleaning.
DO NOT put the burner heads in a dishwasher.
n n
Make sure they are absolutely dry before replacing.
The Single Ring Burners
When refitting the burner head, make sure that the notch
lines up with the electrode or hole in the base. Check that the
burner head is level and that the cap is fitted centrally on the
burner head (Fig. 6.1).
18