Setup And Wiring; Mounting; Connect The Hsm2Host; Enroll The Hsm2Host - DSC HSM2HOST Installation Manual

Setup and Wiring

This section describes how to set up and wire the HSM2HOST module.

Mounting

Note: Permanently mount the HSM2HOST receiver and wireless devices AFTER placement testing each
device (See "[904] Placement Testing Wireless Devices" on page 13).
Find a place that is:
dry,
l
within operating temperature range,
l
central to the proposed placement of all wireless devices,
l
as high as possible. The range is reduced if mounted below ground level,
l
far from sources of interference, including: electrical noise (computers, televisions, electric motors,
l
appliances, heating and air conditioning units), large metal objects like heating ducts and plumb-
ing which may shield the electro-magnetic waves,
smooth and free of obstructions that block access to the rear of the unit.
l

Connect the HSM2HOST

Caution: Remove all power (AC, DC, telephone lines) from the system while connecting modules to the
Corbus.
To connect the HSM2HOST:
1. With the alarm panel powered down, connect the HSM2HOST to the four-wire Corbus of the
alarm panel according to Figure 1.
2. Once the wiring is complete, power up the security system.
Figure: 1 Wiring Diagram

Enroll The HSM2HOST

The HSM2HOST must be enrolled onto the alarm panel before any wireless devices can be enrolled.
When the alarm system is powered up for the first time, the first keypad or the HSM2HOST (if using a
wireless keypad as the first keypad) can be enrolled.
To do this:
1. Once the HSM2HOST is wired to the alarm panel and power has been applied, power up a wire-
less keypad.
2. Press any button on the keypad to enroll it on the HSM2HOST. The HSM2HOST is then auto-
matically enrolled on the alarm panel.
Alternately, enroll the HSM2HOST on the system at any time using the following procedure:
1. Enter Installer Programming section [902][000] (Auto Enroll All Modules). Modules are auto-
matically detected in the following order:
1– Keypads
2 – Zone Expander
8
Setup and Wiring