Tamper - DSC HSM2HOST Installation Manual

HSM2HOST Installation Manual

Tamper

The HSM2HOST has separate built-in wall and case tampers. The case tamper is disabled by default on
the NA version (enabled on EU version).
Section [804][810] option 3 enables or disables the case tamper. Enable or disable the wall tamper by
fastening the breakaway wall tamper bracket securely to the wall using one of the supplied screws.
The case tamper activates when the case is opened and restores when the case is closed. The wall tamper
on the back of the unit is depressed by the mounting surface when properly installed. If the unit is
removed, the tamper activates. Ensure the mounting surface is smooth and free of obstructions that block
access to the rear of the unit. Electrical wires should not run over or under the module when it is moun-
ted.
Note: The built in wall and case tamper must be installed and enabled for UL/ULC listed Commercial/
Residential Burglary applications.
7