[990][001 - 005] Show All Devices; [999] Reset To Factory Defaults; Placement Testing Wireless Devices - DSC HSM2HOST Installation Manual

HSM2HOST Installation Manual
To replace a wireless device:
1. Enter Installer Programming section [804] then select one of the following sub-sections:
[921] – Replace wireless zone devices
[922] – Replace wireless key
[923] – Replace sirens
[924] – Replace repeaters
[925] – Replace keypads
2. Press [*] to select a sub-section. The first available device is displayed.
3. Select a device to replace using the scroll keys or go to a specific device by entering a hotkey.
4. Press [*]. When prompted, activate the device (full enrollment) or enter the device ID (pre-enroll-
ment). A message is displayed confirming enrollment.
[804][990][001 – 005] Show All Devices
Use this section to review wireless devices enrolled on the system and to view serial numbers associated
with each device.
To review wireless device information:
1. Enter Installer Programming section [804][990] then select one of the following sub-sections:
[001] – All zones
l
[002] – Repeaters
l
[003] – Sirens
l
[004] – Wireless keys
l
[005] – keypads
l
2. Press [*] to select a wireless device type. The first available device is displayed.
3. Use the scroll keys to view the enrolled devices.
Note: This option is not fully supported by LED and ICON keypads.

[804][999] Reset to Factory Defaults

Selecting this option resets HSM2HOST programming to factory default settings.

[904] Placement Testing Wireless Devices

This test is used to determine RF signal status for wireless devices and can be performed at a system
keypad or at the individual device. These instructions pertain to testing at the keypad. For instructions on
placement testing at the device, refer to the installation sheet provided with the wireless equipment. The
following test modes are available:
[904][001]-[128] Test wireless zones
[904][521]-[528] Test all repeaters
[904][551]-[566] Test all sirens
[904][601]-[632] Test all wireless keys Test individual wireless keys. Once in this section,
[904][701]-[716] Test all keypads
Two test results are provided:
24-hour: Average results of signal strength testing over a 24-hour period.
l
Now: Signal status results of the current test.
l
A flashing Trouble LED indicates RF interference. The following status indicators may be displayed:
Test wireless devices individually by zone. Zones with
vanishing contacts must be activated to placement test.
Test each enrolled wireless repeater. 521-528 for repeat-
ers 1-8
Test each enrolled wireless siren. 551-566 for sirens 1-
16
press a button on the wireless key to begin the test.
601-632 for wireless keys 1-32.
Test each enrolled keypad. 701-716 for keypads 1-16
13