Setup & Wiring; Choose A Mounting Location - DSC HSM2HOST8 Installation Manual

H S M 2 H O S T I n s t a l l a t i o n M a n u a l
1.1 Setup & Wiring
This section describes how to set up and wire the HSM2HOST module.
1.1.1 In the Box
Check that the following parts are in the package:
• HSM2HOST module
• Mounting hardware
• Installation manual

1.1.2 Choose a Mounting Location

NOTE: Permanently mount the HSM2HOST receiver and wireless devices AFTER placement testing each device (section Permanently Mount
on page 3).
Find a place that is
• dry,
• within operating temperature range,
• central to the proposed placement of all wireless devices,
• as high as possible. The range is reduced if mounted below ground level,
• far from sources of interference, including: electrical noise (computers, televisions, electric motors, appliances, heating and air conditioning
units), large metal objects like heating ducts and plumbing which may shield the electro-magnetic waves,
• smooth and free of obstructions that block access to the rear of the unit.
1.1.3 Connect the HSM2HOST
Caution: Remove all power (AC, DC, telephone lines) from the system while connecting modules to the Corbus.
1. With the alarm panel powered down, connect the HSM2HOST to the four-wire Corbus of the alarm panel according to Figure 1.
2. Once the wiring is complete, power up the security system.
Figure: 3 Wiring
1.1.4 Enroll The HSM2HOST
The HSM2HOST must be enrolled onto the alarm panel before any wireless devices can be enrolled.
At initial power-up of the alarm panel
When the alarm system is powered up for the first time, the first keypad or the HSM2HOST (if using a wireless keypad as the first keypad) can be
enrolled. To do this:
1. Once the HSM2HOST is wired to the alarm panel and power has been applied, power up a wireless keypad.
2. Press any button on the keypad to enroll it on the HSM2HOST. The HSM2HOST is then automatically enrolled on the alarm panel.
Alternately, enroll the HSM2HOST on the system at any time using the following procedure:
1. Enter Installer Programming section [902] > [000] (Auto Enroll All Modules). Modules are automatically detected in the following order:
1 Keypads
2 Zone Expander
3 Output Module
4 HSM2HOSTx
5 Audio Verification Module
6 Power Supply 1A
2. When prompted, press [*] to enroll.
Alternately,
1. Enter Installer Programming section [902] > [001] (Enroll Modules).
2. When prompted, key in the serial number found on the back of the HSM2HOST. The module is enrolled.
1.1.5 Delete the HSM2HOST
To remove the HSM2HOST from the system:
1. Enter Installer Programming section [902] > [106] (Delete HSM2HOSTx).
2. Press [*] to delete.
CORBUS TO
HSM2HOST
2
S e t u p & W i r i n g