ROBINHOOD RHCI9SS - IMPRESA Installation Instructions

INSTALLATION INSTRUCTIONS CANOPY HOOD
(PLEASE NOTE PRODUCT MAY VARY SLIGHTLY FROM THE PICTURE)
PRE-INSTALLATION
Thank you for purchasing a quality, stainless steel canopy hood.
We have a high standard of quality control and each canopy hood is tested and approved before it
leaves the factory.
IMPORTANT
Please read the entire instructions before installing the canopy hood
•
Always switch the power off prior to installation, servicing or cleaning the canopy hood.
•
Never use the canopy hood without the filters.
•
Stainless steel is very easily damaged during installation if abraded or knocked by tools.
•
Note all ducting must comply with local requirements and building codes.
•
A power outlet should be within 1200mm from the motor assembly and can be either on the
•
wall, behind the chimney or in the ceiling.
All electrical work must be done in accordance with local and/or national electrical
codes as applicable. For safety, this product must be earthed. If you are unfamiliar with
methods of installing electrical wiring, employ the services of a qualified electrician.
Turn off power at service entrance before installing wiring or servicing this product.
The canopy hood is heavy please ensure adequate care when installing the canopy
hood to prevent personal injury.
lbs
The canopy hood must be installed onto a solid wall or solid stud. (Weight = 15 Kg)
Model No: RHCI9SS - IMPRESA
114370 Issue C
ECN 07 007