Log Set Installation - Regency Fireplace Products GFI300LNG-R Owners & Installation Manual

Read the instructions below carefully and refer to the images. If the logs are broken do not use the unit until they are replaced. Broken logs can
interfere with pilot operation.
Improper positioning of the logs may create carbon build-up and can alter the unit's performance which is not covered under warranty.
*For Touch Ups: Dark Brown Paint is included for log set.
1 Rear Log
2 Right Log
3 Centre Log
4 Left Log
5 Right Upright Cross Log
6 Left Upright Cross Log
7 Left Front Log Piece
8 Centre Front Log Piece
6
7
4
8
1. Line up pin holes on the bottom of Log 1 with pins behind burner as
shown below.
Logs 1 - fi ts over pins behind
Logs 1 - in position
Regency GFI300L Gas Fireplace Inbuilt

LOG SET INSTALLATION

5
1
2
3
1
burner
1
2. Locate pin hole on Log 2 and line up with pin on the right side of the
burner. The left end of Log 2 will rest against a tab in location shown
below.
Logs 2 - fi ts over pin on left side
- rests against tab on right
Logs 2 in position
3. Place Log 3 on the centre of the burner, rest the log against the centre
tabs.
Logs 3 - place in centre of
burner, resting against tabs
INSTALLATION
2
1
2
2
3
17