versa VX-AP1WPro User Manual page 36

Wireless Access Point User Guide
WMM (Wi-Fi Multimedia)
Enable WMM Support
No Acknowledgement
Parameters
Disassociated Timeout
Fragmentation
Beacon Interval
RTS/CTS Threshold
Preamble Type
Output Power Level
802.11b
Protection Type
Short Slot Time
Protection Mode
Protection Rate
Check this to enable WMM (Wi-Fi Multimedia) support in the
Access Point. If WMM is also supported by your wireless
clients, voice and multimedia traffic will be given a higher
priority than other traffic.
If enabled, then WMM acknowledgement is disabled. Depend-
ing on the environment, disabling acknowledgement may
increase throughput slightly.
This determines how quickly a Wireless Station will be consid-
ered "Disassociated" with this AP, when no traffic is received.
Enter the desired time period.
Enter the preferred setting between 256 and 2346. Normally,
this can be left at the default value.
Enter the preferred setting between 20 and 1000. Normally, this
can be left at the default value.
Enter the preferred setting between 256 and 2346. Normally,
this can be left at the default value.
Select the desired option. The default is "Long". The "Short"
setting takes less time when used in a good environment.
Select the desired power output. Higher levels will give a
greater range, but are also more likely to cause interference with
other devices.
Select the desired option. The default is CTS-only.
Enable or disable this setting as required.
The Protection system is intended to prevent older 802.11b
devices from interfering with 802.11g transmissions. (Older
802.11b devices may not be able to detect that a 802.11g
transmission is in progress.) Normally, this should be left at
"Auto".
Select the desired option. The default is 11 Mbps.
32