versa VX-AP1WPro User Manual page 19

Data - Status Screen
Access Point
Access Point Name
MAC Address
Domain
Firmware Version
TCP/IP
IP Address
Subnet Mask
Gateway
DHCP Client
2.4 GHz Wireless
BSSID
Channel/Frequency
Wireless Mode
AP Mode
Bridge Mode
Buttons
Profile Status
2.4 GHz Statistics
Remote AP Status
Log
Stations
The current name will be displayed.
The MAC (physical) address of the Wireless Access Point.
The region or domain, as selected on the Basic Wireless screen.
The version of the firmware currently installed.
The IP Address of the Wireless Access Point.
The Network Mask (Subnet Mask) for the IP Address above.
Enter the Gateway for the LAN segment to which the Wireless
Access Point is attached (the same value as the PCs on that LAN
segment).
This indicates whether the current IP address was obtained from a
DHCP Server on your network.
It will display "Enabled" or "Disabled".
The name of BSS is displayed. usually, the value of BSSID is
equal to the MAC address of wireless for AP.
The Channel currently in use is displayed.
The current mode (e.g. 802.11g) is displayed.
The current Access Point mode is displayed.
The current Bridge mode is displayed.
Click this to open a sub-window which displays further details
about each security profile.
Click this to open a sub-window where you can view Statistics on
data transmitted or received by the Access Point.
Click this to open a sub-window where you can view further
information about each Remote AP. It only can be used when the
device work in WDS mode.
Click this to open a sub-window where you can view the log, re-
start the log, or save the current log to a file.
Click this to open a sub-window where you can view the list of
all current Wireless Stations using the Access Point.
Setup
15