versa VX-AP1WPro User Manual page 34

Wireless Access Point User Guide
PTP Bridge AP
MAC Address
In PTMP mode,
only allow
specified APs
Set PTMP APs
Parameters
Channel No
Current Channel
No.
This is not required unless the Bridge Mode is "Point-to-Point Bridge
(PTP)". In this case, You can either enter the MAC address directly, or,
if the partner AP is on-line and broadcasting its SSID, you can click
the "Select AP" button and select it from a list of available AP.
This is only functional if using Point-to-Multi-Point Bridge (PTMP)
mode. If enabled, you can specify the MAC addresses of the APs
which are allowed to connect to this AP. To specify the allowed APs:
•
Enable this checkbox
•
Click the button "Set PTMP APs".
•
On the resulting sub-screen, enter the MAC addresses of the
allowed APs.
Use this to open a sub-window where you can specify the MAC
addresses of the APs which are allowed to connect to this AP. This is
only functional if using Point-to-Multi-Point Bridge (PTMP) mode and
you has enabled the checkbox "In PTMP mode, only allow specified
APs".
•
If "Automatic" is selected, the Access Point will select the best
available Channel.
•
If you experience interference (shown by lost connections and/or
slow data transfers) you may need to experiment with manually
setting different channels to see which is the best.
This displays the current channel used by the Access Point.
30