Setting Entries On The Setup Menu, General - Fronius Galvo 1.5-1 Operating Instructions Manual

If no key is pressed for 2 minutes,
-
-
-
Setting entries on
1
the Setup menu,
2
general
3
The first digit of a value to be set flash-
es:
The second digit of the value flashes.
the whole value to be set flashes.
The currently selected menu item is dis-
played.
24
G R A P H
The inverter switches from wherever it is on the menu level back to the 'NOW' display
mode (exception: 'Standby' Setup menu entry),
the display backlighting goes out.
The amount of energy currently being fed in is displayed.
Enter the SETUP menu item
Use the 'Up' or 'Down' keys to select the desired menu item
Press 'Enter'
Use the 'Up' or 'Down' keys to select
4
a value for the first digit
Press 'Enter'
5
Repeat steps 4 and 5 until ...
6
Press 'Enter'
7
Repeat steps 4 - 6 as required for
8
units or other values that are to be set
until the appropriate unit or the value
flashes.
Press the 'Enter' key to save and ap-
9
ply the changes.
To discard the changes, press the
'Esc' key.
To exit a menu entry, press the 'Back'
4
key
The menu level appears
The available settings are displayed:
Use the 'Up' or 'Down' keys to select
4
the desired setting
Press the 'Enter' key to save and ap-
5
ply the setting.
To discard the setting, press the 'Esc'
key.
The currently selected menu item is dis-
played.