ECM Elektronika Profi Due Instruction Manual page 24

Position "0": water tank
Machine in use with direct water connection
Connect the water connecting hose to the water supply adapter (image 1).
When using the machine with direct water connection, please turn the valve to the side of the water supply adapter
(image 1). The water supply valve is located in the rear part of the bottom panel (image 1). Additionally, place the
switch behind the drip tray into position "1" (image 2). Please make sure that your water tap is always open during
water-connection usage so that the machine never runs out of water!
image 1
Machine in use with water tank
When using the machine with water tank, please turn the valve into the direction of the machine foot (image 3).
Additionally, place the switch behind the drip tray into position "0" (image 4).
image 3
Important
• Please make sure that only experienced specialists are connecting the machine to the water supply
and installing a pressure regulator.
• To avoid calcification of the machine a water softener is recommended. An 8l-water softener
(item.-no. 89530) is available in the ECM range of products.
Important
• In case you should decide on a direct connection of the machine to the drain system, a hole has to
be drilled in the bottom of the drip tray. This alteration can be carried out by experienced
specialists or by ECM Manufacture service.
• Connect a hose (inner diameter 15 mm) to the designated connector on the back side of the
machine and to a preinstalled siphoned drain.
Instruction manual ELEKTRONIKA PROFI DUE
Valve in position for operating machine
with direct water connection
Place switch into position "1" for direct
water connection
Water supply adapter
Valve in position for operating machine
with water tank
Place switch into position "0"when
operating machine with water tank
Machine foot
Position "1": direct water connection
image 4
23
ENGLISH
image 2