ICON inspire 5G2 User Manual page 23

3.1 Knobs

There are two function settings (rotate & enter) for all the knobs as the table
below shows:
Knobs Function
"Enter
(Click the lower
part of the knob)"
MIDI
message Settings
type
Channel
Note
Note
Up value
Down value
Channel
Control
CC
Channel
Program
Program
Value Description
Set the midi
1 to
channel of the
16
correspondence knob
-1(C) Set the note value of
to the correspondence
9(G) knob
This value will be
send when releasing
the pressed knob (i.e.
0 to
release from enter). It
127
will be send together
with selected Note
value.
This value will be
send when pressing
0 ro down the knob (i.e.
127 enter). It will be send
together with selected
Note value.
Set the midi
1 to
channel of the
16
correspondence knob
Set the CC value of
0 to
the correspondence
127
knob
Set the midi
1 to
channel of the
16
correspondence knob
Set the program
0 to
value of the
127
correspondence knob
"All" Check box
Check this box
to assign the
selected channel
to all 8-knobs
-
Check this box
to assign the
selected value to
all 8-knobs
Check this box
to assign the
selected value to
all 8-knobs
Check this box
to assign the
selected channel
to all 8-knobs
-
Check this box
to assign the
selected channel
to all 8-knobs
-
23