ICON inspire 5G2 User Manual page 21

Note: You may activate the four VirtualPort™ & the MIDI Out port for each zone,
Send Data Send Data
so that its message will be send to the activated port(s). To activate, "check" the
corresponding check box.
2. Pad – Assign the MIDI function to your InSpire G2's drum-
pads
Firmware Upgrade Firmware Upgrade

There are 12-pads with four layers (48-pads in total) that you can assign a midi
function independently. To assign a pad, click it (it will turn blue), and select the
function on the left table as described below.



There are 3 different modes for selection including "Note", "Control" and
"Programme". Each mode has its own midi message and setting as the table
below shows.
Mode
Note
Transpose
Octave Chan
Exit Exit Send Data Send Data
Settings Value
Channel 1 to 16
+1 to
Velocity
+12
-1(C) to
Note
9(G)
Vel Start End
Exit Exit
Layer1
Layer2
Layer3
Layer4
Send Data Send Data
Description
Set the midi channel of
the correspondence pad
Set the velocity curve of
the correspondence pad
Set the note value of the
correspondence pad
MIDI Out Device1 Device2 Device3
Mode
All
Chan
Device1
Device2
Vel
Device3
CC
Device4
Vale2
MIDI Out
Exit Exit Send Data Send Data
"All" Check box
Check this box to assign
the selected channel to
all the 16-pads at the
correspondence layer
Check this box to assign
the selected velocity to
all the 16-pads at the
correspondence layer
Device4
All
Exit Exit
Diagram 11
-
21