ICON inspire 5G2 User Manual page 22

"Control
(CC value)"
Program


Note:

Same as the key-switch, you may activate the four VirtualPort™ & the
MIDI Out port for each individual pad. So that its message will be send to the
activated port(s). To activate, "check" the correspondence check box.
3. Controller – Assign the MIDI function to your InSpire G2's
controller
Encoder1
Y
x
Firmware Upgrade Firmware Upgrade
Note:

If you are using Mackie Control or HUI mode, you do not need to adjust
this setting. Just simply select the correct DAW mode according to your DAW
when you turn on the power. (Refer P.14 for details).



Below is described the settings for more advanced users who would like to set
up their own MIDI mapping for the InSpire G2 controller.
22
Channel 1 to 16
CC 1 value 0 to 127
CC2 value 0 to 127
Channel 1 to 16
Program 0 to 127
Encoder2 Encoder3 Encoder4 Encoder5
Y
Y
x
x
Set the midi channel of
the correspondence pad
Set the first CC value
(Pad pressed down) of the
correspondence pad
Set the second CC value
(Pad released) of the
correspondence pad
Set the midi channel of
the correspondence pad
Set the program value of
the correspondence pad
Encoder6 Encoder7 Encoder8
Y
x
Save File Save File Load File Load File
Check this box to assign
the selected channel to
all the 16-pads at the
correspondence layer
-
Check this box to assign
the selected CC value
to all the 16-pads at the
correspondence layer
Check this box to assign
the selected channel to
all the 16-pads at the
correspondence layer
-
Mode
select button
All
CH
Note
Down Vale
Up Vale
Led return back
Device1
Device2
Device3
Device4
MIDI Out
MIDI Devices MIDI Devices
Send Data Send Data
Diagram 12