Tail Wheel Assembly Installation - RC Guys Super Decathlon ARF Assembly Manual

Tail Wheel Assembly Installation
Collect these parts.
ÿ 1 ­ factory assembled tail wheel bracket
ÿ 2 ­ wood screws
NOTE: The extra part in the bag (flat bar with 4 holes) is for an alternate method of attachment of the Tail Wheel
Springs.
Position the Tail Wheel Assembly over the Fuselage and mark through
the holes.
Drill pilot holes and secure the tail wheel assembly to the Fuselage
using the supplied hardware (2 x wood screws).
HINT: Use thin CA to harden all screw holes into wood and balsa
after the screw has been threaded in and taken back out.
NOTE: Tail Wheel Springs are installed after the Rudder.
Collect the pre­assembled tail wheel bracket and hardware.
­ 2 ­