Radio Set Up; Control Surface Throw - RC Guys Super Decathlon ARF Assembly Manual

Radio Set Up
You will need to locate your receiver and batteries on the upper plywood deck.
We used foam wrap and plastic electrical straps to secure our receiver and battery.
You will need a Y Servo Extension to connect the 2 Aileron Servo Extensions if you are connecting to the same
receiver channel.
Tip: You will need to balance your model before choosing the location of your batteries.
NOTE: The C of G is on the main Wing spar. 4­1/8" from the leading edge of the Wing nearest the
Fuselage.
Control Surface Throws
Rudder +/­ 1­1/2" low and 2­1/2" high
Elevators +/­ 3/4" low and 1­1/4" high
Ailerons +/­ 3/4" low and 1­1/4" high
Assemble the entire model and make any changes to suit.
HINT: This airplane flies best with some Rudder mixed with Aileron. If you have a programmable radio, we
suggest 14%. Also, the Ailerons work best with a 2:1 ratio of Differential, twice as much up as down.
­ 26 ­