Optional Tail Support Flying Wires - RC Guys Super Decathlon ARF Assembly Manual

Optional Tail Support Flying Wires
Some of the hardware has been included in your kit to install the optional Flying Wires on the tail of your
airplane. These are recommended if you intend to use larger engines (engines over 3.5hp)
Material List
8­ Clevises
8­ Metal Straps (pre drilled)
8­ Rigging Couplers
8 Aluminum Crimps
3­ Bolts with NyLoc Nuts
2­ Screws
1­ Cable Wire
Bend each predrilled Metal Strap in the middle to the angle needed to run each of the 4 sections of Cable Wire.
Mark these locations and drill 1/16" holes:
­ ¾" down fro the top of the fin, 3/8" in from the trailing edge
­ 8½" across each side of the Stabilizer from the fin, 3/8" in from the trailing edge
­ at the bottom of the Fuselage below the Stabilizer, 3/8" from the rear edge of the Fuselage
Secure the Straps to the side of the Fuselage with a screw and on the fin and stab with one bolt going through
the Strap on each side.
Into each Clevis, thread one of the Rigging Couplers half way into the Clevis, allowing for later adjustment if
needed.
­ 28 ­