Wheel Pant Installation
Collect these parts.
ÿ 2 wheel pants
ÿ 4 – 632 T nuts
ÿ 4 632 x ½ socket head bolts
ÿ 4 flat washers
ÿ 4 locking washers
Using a Dremel, ensure the holes in the wheel pants fit the axel nuts.
Line up the wheel pant with the graphics on the Fuselage so that they are parallel and even.
Mark or scribe through the holes in the Landing Gear legs onto the wheel pants.
Drill 2 x 1/8 dia. holes on these marks.
Install the T nuts from inside the wheel pants.
NOTE: It is recommended to apply Epoxy inside the wheel pant
behind the plywood insert for extra strength.
10