The Wps Screen - ZyXEL Communications eir F1000 User Manual

Chapter 5 Wireless
Table 20 Wireless > MAC Authentication (continued)
LABEL
Add new MAC
address
#
MAC Address
Delete
Apply
Cancel

5.5 The WPS Screen

Use this screen to configure WiFi Protected Setup (WPS) on your Device.
WPS allows you to quickly set up a wireless network with strong security, without having to
configure security settings manually. Set up each WPS connection between two devices. Both
devices must support WPS. See
Note: The Device applies the security settings of the SSID1 profile (see
page
mode of SSID1 to WPA2-PSK or No Security.
Click Network Setting > Wireless > WPS. The following screen displays. Select Enable and click
Apply to activate the WPS function. Then you can configure the WPS settings in this screen.
Figure 41 Network Setting > Wireless > WPS
82
DESCRIPTION
Click this if you want to add a new MAC address entry to the MAC filter list below.
Enter the MAC addresses of the wireless devices that are allowed or denied access to the
Device in these address fields. Enter the MAC addresses in a valid MAC address format, that
is, six hexadecimal character pairs, for example, 12:34:56:78:9a:bc.
This is the index number of the entry.
This is the MAC addresses of the wireless devices that are allowed or denied access to the
Device.
Click the Delete icon to delete the entry.
Click Apply to save your changes.
Click Cancel to exit this screen without saving.
Section 5.10.9.3 on page 98
70). If you want to use the WPS feature, make sure you have set the security
for more information about WPS.
Section 5.2 on
eir F1000 Modem User's Guide