ZyXEL Communications eir F1000 User Manual page 53

Table 7 Network Setting > Broadband > Add New WAN Interface/Edit (Bridge Mode) (continued)
LABEL
Active
802.1p
802.1q
QoS
Rate Limit
Apply
Cancel
If you select ADSL over ATM as the interface type, the following screen appears.
Figure 26 Network Setting > Broadband > Add New WAN Interface/Edit (ADSL over ATM-Bridge
Mode)
The following table describes the fields in this screen.
Table 8 Network Setting > Broadband > Add New WAN Interface/Edit (ADSL over ATM - Bridge
Mode)
LABEL
General
Active
Name
Type
eir F1000 Modem User's Guide
DESCRIPTION
Select this to add the VLAN Tag (specified below) to the outgoing traffic through this
connection.
IEEE 802.1p defines up to 8 separate traffic types by inserting a tag into a MAC-layer frame
that contains bits to define class of service.
Select the IEEE 802.1p priority level (from 0 to 7) to add to traffic through this connection.
The greater the number, the higher the priority level.
Type the VLAN ID number (from 0 to 4094) for traffic through this connection.
Enter the rate limit for the connection. This is the maximum transmission rate allowed for
traffic on this connection.
Click Apply to save your changes.
Click Cancel to exit this screen without saving.
DESCRIPTION
Select this to activate the WAN configuration settings.
Enter a service name of the connection.
Select ADSL over ATM as the interface for which you want to configure here. The Device
uses the ADSL technology for data transmission over the DSL port.
Chapter 4 Broadband
53