The Routing Screen - ZyXEL Communications eir F1000 User Manual

Chapter 7 Routing

7.2 The Routing Screen

Use this screen to view and configure the static route rules on the Device. Click Network Setting
> Routing > Static Route to open the following screen.
Figure 66 Network Setting > Routing > Static Route
The following table describes the labels in this screen.
Table 37 Network Setting > Routing > Static Route
LABEL
Add new static
route
#
Status
Name
Destination IP
Subnet Mask/
Prefix Length
Gateway
Interface
Modify
128
DESCRIPTION
Click this to configure a new static route.
This is the index number of the entry.
This field displays whether the static route is active or not. A yellow bulb signifies that this
route is active. A gray bulb signifies that this route is not active. Click the bulb to enable/
disable the static route.
This is the name that describes or identifies this route.
This parameter specifies the IP network address of the final destination. Routing is always
based on network number.
This parameter specifies the IP network subnet mask of the final destination.
This is the IP address of the gateway. The gateway is a router or switch on the same
network segment as the device's LAN or WAN port. The gateway helps forward packets to
their destinations.
This is the WAN interface used for this static route.
Click the Edit icon to edit the static route on the Device.
Click the Delete icon to remove a static route from the Device. A window displays asking
you to confirm that you want to delete the route.
eir F1000 Modem User's Guide