IAG IOM75S User Manual page 9

Operating instructions for 3 key touch
digital timer ( E.G.O. Basic Timer )
3.3 Touchpad SELECT
Using Touchpad SELECT allows to step through the
sequences of function.
TIME of DAY
SELECT
MINUTE MINDER
SELECT
COOKING TIME
SELECT
END of COOKING
SELECT
TIME of DAY
SELECT
Setting value of
ACOUSTIC
Touching Touchpad SELECT momentarily, the next
following function is chosen.
Touching Touchpad SELECT permanently causes no
automatic change. Touching Touchpad SELECT for
more than 10 seconds an ACOUSTIC SIGNAL according
chapter 5.2 occurs and the SELECT mode terminates
automatically.
3.4 Touchpads SET(+) and SET(-)
Within 5 seconds after selection of a function, the time or
the signal volume can be set with Touchpad SET (+) or SET
(-).
Display
setting
setting
TIME
setting
Current
setting
SIGNAL
iAG 750mm Oven OPERATING INSTRUCTIONS FOR 3 KEY TOUCH DIGITAL TIMER
4.0 Functions
4.1 Start of a function
5 seconds after setting, a set time or volume is accepted
and the chosen function starts automatically. The display
shows the current TIME of DAY, except the MINUTE
MINDER is active. In this case the display shows the
remaining time of the MINUTE MINDER.
4.2 Power ON / intlal operation
Safety advice:
Line voltage 230V at the conductive keys! Do not touch
without insulation.
Use correct insulation, that the user can not touch the
conductive keys directly.
After connecting the unit to the mains, the display shows
the default TIME of DAY 12:00 h:min flashing. In order to
avoid the heaters to automatically switch on after a power
failure, the relay contact opens as soon as power returns.
Touching any pad the relay contact closes and the display
shows the default time
12:00 h:min permanently.
The colon and the symbol
possible now to set the current TIME of DAY as described
in chapter 4.3.2
4.3 TIME of DAY
4.3.1 Select TIME of DAY mode
Step through the sequences of function with Touchpad
SELECT as described in chapter 3.3 until the symbol
flashes.
4.3.2 Set TIME of DAY
Set TIME of DAY by SET (+) or SET (-) as described in
chapter 3.4
Display : 0.....24h
Fomat : h:min
4.4 Set ACOUSTIC SIGNAL volume
Step through the sequences of function until the display
shows the chosen ACOUSTIC SIGNAL L1,L2 or L3. The
signal volume can be increased res. Dereased with
Touchpad SET (+) or SET (-). The acoustical feedback
sounds in the selected volume.
ACOUSTICAL SIGNAL volume
L1 = low
L2 = medium
L3 = loud
continue to flash. It is
9