Electric Connection - IAG IOM75S User Manual

Installation
Fastening the oven
Insert the appliance into the compartment; open the oven door and fasten the oven to the cabinet using the four screws
"A", remembering to place the special spacers provided between the hole and the screw itself.

Electric connection

Cookers with a three-pole power supply cable are designed to operate with alternated current at the supply frequency
and voltage indicated on the data plate (at the bottom of the oven dashboard). The earthing conductor of the cable is the
yellow-green conductor.
Connecting the power supply cable to the mains
The appliance must be directly connected to the mains using an omnipolar circuit-breaker with a minimum contact
opening of 3 mm installed between the appliance and the mains, suitable for the load indicated and complying with
current directives (the earthing wire must not be interrupted by the circuit-breaker).
The power supply cable must be positioned so that it does not exceed 50°C more than room temperature at any point of
its length.
Before making the connection check that:
the limiter valve and the home system can support the appliance load (see data plate);
■ ■
the power supply system has an efficient earthing connection which complies with the provisions of current
■ ■
regulations;
the socket or omnipolar circuit-breaker is easily accessible once the cooker has been installed.
■ ■
NOTE: do not use reducers, adaptors or shunts as they could cause overheating and burns.
IAG 750mm Oven INSTALLATION 23