Accessory Packages; Multiple Hanging & Draft Inducer Positions - Space-Ray LTU Series Installation And Operation Instructions Manual

12.0)

ACCESSORY PACKAGES

A. A. A. A. Elbow Accessory Package, Part #43208010 Elbow Accessory Package, Part #43208010 Elbow Accessory Package, Part #43208010 Elbow Accessory Package, Part #43208010
(Option for LTS Series Only)
Contains:
Elbow, #43175000......QTY–1
#10-16 x ½ Self-Drilling Screws, #02189020......QTY–2
Tube Coupling, #30462980......QTY–1
B. B. B. B. Corner Reflector Accessory Package, Part #43342000 Corner Reflector Accessory Package, Part #43342000 Corner Reflector Accessory Package, Part #43342000 Corner Reflector Accessory Package, Part #43342000
(Option for LTS Series Only)
Contains:
Corner Reflector Assembly, #43345000......QTY–1
Speed Clips, #02266010......QTY–4
C. C. C. C. Exhaust Hood Package, Part #42924000 Exhaust Hood Package, Part #42924000
Exhaust Hood Package, Part #42924000 Exhaust Hood Package, Part #42924000
Contains:
Exhaust Hood Assembly, #42925540......QTY–1
#8-18 x ½ Self-Drilling Screws, #02189030......QTY–2
13.0) MULTIPLE HANGING & DRAFT INDUCER POSITIONS
The heater can be mounted horizontally or at an angle of 45º maximum from horizontal. Make sure the long axis
of heater is level.
Multiple draft inducer positions can also be used as shown in the diagrams. This allows for the desired
configuration of flue venting. Regardless of the position chosen, the junction box must remain horizontal as
shown. This may be achieved as follows:
1. Remove the three (3) ¼-20 locknuts securing the motor and blower wheel assembly.
2. Pull the motor and blower wheel assembly with the motor plate slightly from the end of the housing
studs. Use care not to damage the motor leads.
3. Rotate the junction box assembly to the upright position using the multi-hole mounting bracket.
-30-
Form #43155040
May 2013