OPERATION 2. DuST ExTRACTION ADAPTOR 3. CONTROLS The tool is recommended for use with a residual current 1. Slide the dust extraction adaptor into the dust extraction port. device with a rated residual current of 30mA or less. On/ Off Switch To turn on, push the ON/OFF switch forward to “I”...
Page 4
4. Place the sander on the work piece, ensuring the whole area of the base is in contact with the work surface. 5. Move the sander over the surface of the work in a circular motion with an even, moderate pressure. DSR-3000...
Finer grit is then used to finish the surface. Always continue sanding with brushes at the same time. each grade of sandpaper until the surface is uniform. Note: Ozito Industries will not be responsible for any MATERIAL AppROpRIATE GRIT...
Page 6
Model No. DSR-3000 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 The following is a list of spare parts carried by Ozito. Please contact Customer Service for any parts not listed. Item Item Description part No.
• Failure to perform maintenance as set out within the instruction manual. • If the tool is disassembled or tampered with in any way. • Professional, industrial or high frequency use. OZITO 1213 Australia/New Zealand (Head Office) 1-23 Letcon Drive, Bangholme, Victoria, Australia 3175.
Need help?
Do you have a question about the DSR-3000 and is the answer not in the manual?
Questions and answers