Table of Contents
Related Manuals for Ozito DETAIL SANDER
Summary of Contents for Ozito DETAIL SANDER
- Page 1 WHAT’S IN THE BOX DETAIL SANDER Detail Sander 125W INSTRUCTION MANUAL Dust Bag SPECIFICATIONS Motor: 125W No Load Spead: 14,000 opm Paper Fitment: Hook and Loop Power Cord: 2m SAA Weight: 1.02kg ozito.com.au Sandpaper Sheet DSR-2100...
-
Page 2: Know Your Product
KNOW YOUR PRODUCT SETUP & PREPARATION 1. HOOK AND LOOP SANDING SHEET DETAIL SANDER 1 On/Off Switch 3 Soft Grip Ensure the tool is disconnected from the power supply before 2 Hook & Loop Backing Pad 4 Dust Bag Adaptor performing any of the following operations. -
Page 3: Operation
OPERATION 2. DUST BAG 3. ON/OFF SWITCH The tool is recommended for use with a residual current device with a rated residual current of 30mA or less. Install 1. Connect the tool to the mains power supply. 1. Push the dust bag onto the dust extraction port. - Page 4 4. SANDING 1. Secure the material to be sanded. 2. Firmly grasp the sander and turn the sander on. 3. Let the motor build up to maximum speed. Gradually lower it onto the workpiece with a slight forward movement. 4. For optimum results, use either of these strokes. Backward/ Forward Side to Side 5.
-
Page 5: Maintenance
If the surface is rough, start with a coarse grit and sand until the surface is Note: Ozito Industries will not be responsible for any damage or injuries uniform. Medium grit may then be used to remove scratches left by the coarser caused by the repair of the tool by an unauthorised person or by mishandling grit. - Page 6 Tool: 125W Detail Sander SPARE PARTS Model No. DSR-2100 5 6 7 8 9 The following is a list of spare parts carried by Ozito. Please contact Customer Service for any parts not listed. Item Item Description Part No. Description Part No.
-
Page 7: Electrical Safety
Replace the extension lead if damaged or defective. Note: The supply of 230V and 240V on Ozito tools are interchangeable for Australia and New Zealand. When using an extension lead on a reel, always unwind the lead completely. Use of an extension lead not suitable for the power input of the tool or which is damaged or defective may result in a risk of fire and electric shock. -
Page 8: Warranty
• Failure to perform maintenance as set out within the instruction manual. • If the tool is disassembled or tampered with in any way. OZITO Australia/New Zealand (Head Office) 1-23 Letcon Drive, Bangholme, Victoria, Australia 3175. 0712...