Specifications - Toro Groundsmaster 3500-D Service Manual

Specifications

MOUNTING: All cutting units are supported by equal
length, independent lift arms and are interchangeable to
all three cutting unit positions.
CONSTRUCTION: Deck chamber is welded 10 and 12
gauge steel. Deck frame is welded 1--1/2 inch square
tubing with 7 gauge side supports.
HEIGHT- -OF- -CUT RANGE: 3/4 to 4 inch (1.91 to 10.16
cm) in 1/4 inch (.64 cm) increments. Height--of--cut ad-
justment is made by repositioning deck on deck frame.
DECK DRIVE: Closed loop, integrated relief, hydraulic
system operates cutting deck hydraulic motors. Blade
spindles are 1--1/4 inch shafts supported by greasable,
tapered roller bearings.
CUTTING BLADE: Each cutting unit equipped with 27
inch (68.6 cm) length, .25 inch (6 mm) thick, heat
treated, steel blade. Anti--scalp cup installed on cutting
blade. The standard blade is optimized for most cutting
applications. Optional high lift, angle sail, and Atomic
blades are available for those situations where the stan-
dard blade is not ideal.
Cutting Units (Rev. D)
DISCHARGE: Clippings are discharged from the rear of
the mowing decks. Pre--drilled mounting holes allow at-
tachment of optional mulching baffle.
CUTTING UNIT LIFT: Cutting units are controlled with
one lever.
SUSPENSION SYSTEM: A fully floating suspension
with hydraulic counterbalance. Main center pivot allows
side--to--side oscillation. Individual decks supported
with two front rollers and one, full width, rear roller.
WEIGHT: Complete cutting unit weighs 190 lb (86 kg).
OPTIONAL EQUIPMENT: Refer to Cutting Unit Opera-
tor's Manual for cutting deck options.
Page 7 - - 2 Groundsmaster 3500--D