General Information - Toro Groundsmaster 3500-D Service Manual

General Information

Check Engine Oil
The engine is shipped with oil in the crankcase. Howev-
er, oil level must be checked before and after the engine
is first started.
Crankcase holds about 4.0 qts. (3.8 l) with filter.
IMPORTANT: Check level of oil every 5 operating
hours or daily. Change oil after every 50 hours of op-
eration.
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake, and remove key
from the ignition switch. Unlatch and raise hood.
2. Remove dipstick and wipe it with a clean rag. Push
dipstick down into dipstick tube and make sure it is
seated fully. Pull dipstick out and check oil level.
3. If oil level is low, remove oil fill cap and gradually add
small quantities of oil, checking level frequently, until the
oil level reaches the FULL mark on the dipstick.
4. The engine uses any high--quality, 10W30 detergent
oil having the American Petroleum Institute -- API -- "Ser-
vice Classification" CD or better.
5. Install oil fill cap.
6. Close and secure hood.
Kubota Diesel Engine
1
1. Dipstick
1. Oil fill cap
Page 3 - - 4
Figure 1
2
Figure 2
2. Injection pump
Groundsmaster 3500--D
1