Toro Groundsmaster 3500-D Service Manual page 165

Removal
WARNING
Before disconnecting or performing any work
on the hydraulic system, all pressure in the
system must be relieved. See Relieving Hy-
draulic System Pressure in the General Infor-
mation section.
1. Remove rear lift cylinder from the frame and lift arm
using Figure 83 as guide.
2. If hydraulic fittings are to be removed from lift cylin-
der, mark fitting orientation to allow correct assembly.
Groundsmaster 3500--D
Installation
1. If hydraulic fittings were removed from lift cylinder,
install fittings to cylinder using marks made during the
removal process to properly orientate fittings.
2. Install rear lift cylinder to the frame and lift arm using
Figure 83 as guide.
3. Make sure hydraulic tank is full. Add correct oil if nec-
essary (see Check Hydraulic System Fluid).
4. Adjust rear lift arm (see Adjust Rear Lift Arm in Chap-
ter 7 -- Cutting Units).
Page 4 - - 115 Hydraulic System (Rev. D)