Toro Groundsmaster 3500-D Service Manual page 157

Removal
WARNING
Before disconnecting or performing any work
on the hydraulic system, all pressure in the
system must be relieved. See Relieving Hy-
draulic System Pressure in the General Infor-
mation section.
1. Remove steering control valve from the steering col-
umn using Figures 74, 75, and 76 as guides.
Installation
1. Install steering control valve to the steering column
using Figures 74, 75, and 76 as guides. When installing
steering control valve, note position of end cover protru-
sion as shown (Fig. 76).
2. Make sure hydraulic tank is full. Add correct oil if nec-
essary (see Check Hydraulic System Fluid).
Groundsmaster 3500--D
2
6
8
1. Tilt bracket
2. Steering valve bracket
3. Jam nut
4. Flat washer
6
4
1. Cap screw
2. Flange nuts
3. Steering valve bracket
4. Steering arm
Page 4 - - 107
1
3
4
5
7
Figure 75
5. Friction disc
6. Steering tilt lever
7. Steering arm
8. Friction disc
5
3
7
2
Figure 76
5. Steering control valve
6. Steering tilt lever
7. End cover protrusion
Hydraulic System (Rev. D)
1