Hard Disk Drive - NEC Versa LXi Service And Reference Manual

Hard Disk Drive

Use the following procedure to remove the hard disk drive. This procedure assumes the battery
has been removed from the system.
1. Close the LCD and turn over the system.
2. Remove the disk drive as follows:
!
!
A – Screw
B – Hard Disk Drive Lever
!
3-14 Disassembly and Reassembly
Remove the screw that secures the hard disk drive.
Place your finger in the center notch of the hard drive lever and pull up the lever. Be
sure that both sides of the lever are raised. If you encounter any resistance when lifting
the lever, carefully loosen both sides of the lever before lifting.
Hard disk drive in the bay
With the lever raised, place your fingers on the inside edge of the lever and on each
side of the center notch. Pull the drive toward the open side of the battery bay. Do not
apply pressure to the drive surface as you pull.
Disconnecting the drive
C – Hard Disk Drive