Disassembly; Battery - NEC Versa LXi Service And Reference Manual

If you are replacing a SO-DIMM and need to remove one that is already installed, do so as
follows:
!
!
Replace the memory module bay cover and screw.
5.
6. Turn over the system and power on.

Disassembly

This section contains step-by-step disassembly procedures for the system. Reassembly is the
reverse of disassembly. Each procedure is supported by a simplified disassembly illustration to
facilitate removal. The illustrated parts breakdown and parts lists for the system unit are shown
in Chapter 5.
For complete disassembly of the system, follow the disassembly instructions that follow.
When disassembling the system unit, follow these general rules.
!
Turn off the system and disconnect all power and all options, including the AC adapter
(if connected) and battery packs (see the procedures that follow).
!
Do not disassemble the system into parts that are smaller than those specified in the
procedure.
!
Label all removed connectors. Note where the connector goes and in what position it
was installed.
from yourself and your clothing by touching a nearby metal surface.

Battery

Remove the battery pack installed in the NEC Versa LXi system as follows.
Press the locking tabs away from the sides of the SO-DIMM and hold while gently
lifting on the edge of the SO-DIMM.
When the edge of the SO-DIMM pops up and is at approximately a 60 degree angle,
pull the SO-DIMM from the socket.
Removing an installed SO-DIMM
Before handling any internal components, discharge static electricity
Disassembly and Reassembly 3-9