Elation emotion User Manual page 40

w w w . e l a t i o n l i g h t i n g . c o m
DOWNLOAD SYSTEM IMAGE
The EMOTION™ fixture graphics system image is available on the support website.
Please download this file and place it on the desktop for easy access.
PREPARE USB STICK
A USB stick is required; it must be at least 8GB. It is suggested to be USB3.0 to speed
the process. The USB stick is easily prepared by using a helper application called
Rufus. (https://rufus.akeo.ie/) Please see the tech bulletin for detailed instruction on
how to use Rufus.
BOOT TO USB STICK
The graphics server must be reset to access the system restore, it is advised to power
on the Emotion fixture and allow it to start fully.
Once the system is fully up and running (approx. 1 min after power on) be sure to
open the shutter of the fixture. This can be from a control board or by the internal
menu system found under manual control of intensity.
After the shutter is open, insert the USB stick into one of the USB ports, and place a
keyboard into the other port.
Press and hold the graphics system reset button for approx. 5seconds.
Release the reset switch and begin tapping F10 on the keyboard (approx. 3
presses/second) you will see the Elation boot screen being shown from the
projector.
You will see the projector flash a few times while booting; it is searching for the
output source.
Once you see the boot device selection screen (shown below) you can stop
pressing F10.
40
EMOTION™ User Manual Ver. 1