Elation emotion User Manual page 29

w w w . e l a t i o n l i g h t i n g . c o m
FIXTURE IDLE
This is the default value, and can be thought of as the 'no command' mode. Please
use allow the control channel to remain at this value when not in use (Channel 7,
Value of 0)
FIXTURE SHUTDOWN
This command is meant to turn-off the motion system. Note the lamp off must be
sent in a separate command. It is good practice to shutdown the fixture and lamp
before removing power – please allow 5 minutes for the projector lamp to cool
before removing power. Sending the Home All command will 'wake up' a fixture in
shutdown mode.
HOME ALL
This function is used to reset the Pan and Tilt position sensors and allow the system to
start from a known position. Use this command when the Pan and Tilt is not
responding correctly, or if the fixture has been impacted and no longer pointing in
the correct direction.
LAMP STRIKE
This command is used to turn-on the projector lamp. The projector has in-built
protection to allow the lamp to strike only when cool.
LAMP DOUSE
This command is used to turn-off the projector lamp. The projector will have a
notification screen when this command is received. This is useful for ensuring the
projector is responding as intended.
PROJECTOR ORIENTATION
This command is meant to change the orientation of the projected image. For
example if the projector is hung inverted, the projector can 'flip' its output so that
images remain upright. There is also the option to front-project or rear-project the
image.
29
EMOTION™ User Manual Ver. 1