Engine Oil Life Reset - Dodge Challenger 2015 Operating Information Manual

NOTE:
• Holding the Up/Down or Left/Right arrow
buttons will loop the user through the
currently selected menu or options pre-
sented on the screen.
• Main menu and submenu's wrap for con-
tinuous scrolling.
• Upon returning to a main menu, the last
submenu screen viewed within that main
menu will be displayed.
OK Button:
For Digital Speedometer
• Pushing the OK button changes units (MPH
or km/h).
For Screen Setup and Vehicle Settings:
• OK button allows user to enter menu and
submenus.
• Within each submenu layer, the up/down
arrows will allow the user to select the item of
interest.
128
• Pushing the OK button makes the selection
and a confirmation screen will appear (re-
turning the user to the 1st page of the
submenu).
• Pushing the left arrow button will exit each
submenu layer and return to the main menu.
For the Trip and Fuel Economy menus (and
new Performance Timers):
• Information is reset by pushing and holding
the OK button.

Engine Oil Life Reset

Oil Change Required
Your vehicle is equipped with an engine oil
change indicator system. The "Oil Change Re-
quired" message will display in the DID for five
seconds after a single chime has sounded, to
indicate the next scheduled oil change interval.
The engine oil change indicator system is duty
cycle based, which means the engine oil
change interval may fluctuate, dependent upon
your personal driving style.
Unless reset, this message will continue to
display each time you turn the ignition switch to
the ON/RUN position or cycle the ignition to the
ON/RUN position if equipped with Keyless
Enter-N-Go™. To turn off the message tempo-
rarily, push and release the OK button. To reset
the oil change indicator system (after perform-
ing the scheduled maintenance) refer to the
following procedure.
Vehicles Equipped With Keyless Enter-N-
Go™
1. Without pushing the brake pedal, push the
ENGINE START/STOP button and place the
ignition to the ON/RUN position (do not start
the engine).
2. Fully push the accelerator pedal, slowly,
three times within 10 seconds.
3. Without pushing the brake pedal, push the
ENGINE START/STOP button once to return
the ignition to the OFF/LOCK position.
NOTE:
If the indicator message illuminates when
you start the vehicle, the oil change indica-
tor system did not reset. If necessary, repeat
this procedure.