To Arm The System - Dodge Challenger 2015 Operating Information Manual

To Arm The System

Follow these steps to arm the Vehicle Security
Alarm:
1. Make sure the vehicles ignition is cycled to
the "OFF" position (refer to "Starting Proce-
dures" in "Starting And Operating" for further
information).
• For vehicles equipped with Keyless Enter-N-
Go™, make sure the vehicle ignition system
is OFF.
• For vehicles not equipped with Keyless
Enter-N-Go™, make sure the vehicle ignition
system is OFF and the key is physically
removed from the ignition.
2. Perform one of the following methods to lock
the vehicle:
• Push LOCK on the interior power door lock
switch with the driver and/or passenger door
open.
• Push the LOCK button on the exterior Pas-
sive Entry Door Handle with a valid Key Fob
available in the same exterior zone (refer to
"Keyless Enter-N-Go™" in "Things To Know
Before Starting Your Vehicle" for further
information).
• Push the LOCK button on the Remote Key-
less Entry (RKE) transmitter.
3. If any doors are open, close them.
To Disarm The System
The Vehicle Security Alarm can be disarmed
using any of the following methods:
• Push the UNLOCK button on the Remote
Keyless Entry (RKE) transmitter.
• Grasp the Passive Entry Unlock Door Handle
(if equipped, refer to "Keyless Enter-N-Go™"
in "Things To Know Before Starting Your
Vehicle" for further information).
• Advance the vehicle ignition system out of
the OFF position.
NOTE:
• The driver's door key cylinder and the
Trunk button on the RKE transmitter can-
not arm or disarm the Vehicle Security
Alarm.
• The Vehicle Security Alarm remains
armed during power trunk entry. Pushing
the trunk button will not disarm the Ve-
hicle Security Alarm. If someone enters
the vehicle through the trunk and opens
any door the alarm will sound.
• When the Vehicle Security Alarm is
armed, the interior power door lock
switches will not unlock the doors.
The Vehicle Security Alarm is designed to pro-
tect your vehicle; however, you can create
conditions where the system will give you a
false alarm. If one of the previously described
arming sequences has occurred, the Vehicle
Security Alarm will arm regardless of whether
you are in the vehicle or not. If you remain in the
vehicle and open a door, the alarm will sound. If
this occurs, disarm the Vehicle Security Alarm.
If the Vehicle Security Alarm is armed and the
battery becomes disconnected, the Vehicle Se-
curity Alarm will remain armed when the battery
is reconnected; the exterior lights will flash, the
horn will sound. If this occurs, disarm the Ve-
hicle Security Alarm.
15