Table of Contents
Advertisement
Programming Additional
Transmitters
Programming Key Fobs or RKE transmitters
may be performed at an authorized dealer.
Transmitter Battery Replacement
The recommended replacement battery is one
CR2032 battery.
NOTE:
• Perchlorate Material — special handling
may
apply.
See
www.dtsc.ca.gov/
hazardouswaste/perchlorate
• Do not touch the battery terminals that
are on the back housing or the printed
circuit board.
1. Remove the emergency key by sliding the
mechanical latch on the back of the RKE
transmitter sideways with your thumb and
then pull the key out with your other hand.
18
Emergency Key Removal
2. Separating RKE halves requires screw re-
moval – if equipped, and gently prying the
two halves of the RKE transmitter apart.
Make sure not to damage the seal during
removal.
Separating Keyless Ignition Node (KIN)
Transmitter Case
3. Remove the battery by turning the back
cover over (battery facing downward) and
tapping it lightly on a solid surface such as a
table or similar, then replace the battery.
When replacing the battery, match the + sign
on the battery to the + sign on the inside of
the battery clip, located on the back cover.
Avoid touching the new battery with your
fingers. Skin oils may cause battery deterio-
ration. If you touch a battery, clean it with
rubbing alcohol.
Advertisement
Chapters
Table of Contents
